Docs

PrivateLink

Endpoint service

Modifying an endpoint connection

Enable/Disable auto-accept connection

To allow endpoints to quickly establish connections with the endpoint service, you can enable the Auto accept connection feature for the endpoint service. Once enabled, you do not need to manually accept connections. The endpoint service will automatically accept connection requests from endpoints and randomly assign a service resource.

Action description

For services with higher security requirements, you can disable the Auto accept connection feature and manually accept endpoint connections. This helps filter Untrusted connections and prevents unauthorized access, malicious attacks, or operational errors.

Enabling or disabling Auto accept connection feature only affects new connections; existing connections remain unchanged.

Procedures

Use the service provider's account to log in to the Endpoint Service console.

In the top menu bar, select the target project and region.

Click the Service ID of target endpoint service.

In the Service information section, click Enable or Disable next to Auto accept connection.

Click Save to complete the action.

Edit Auto-assign

When Auto accept connection is enabled, the endpoint service randomly assigns an associated service resource upon accepting a connection request. If you want specific service resources to be Excluded from automatic assignment, you can configure them manually.

Action description

When a service resource is added to an endpoint service, all its Availability Zones have auto-assignment enabled by default.

For an Endpoint Service, auto-assign must be enabled on at least one service resource in each Availability Zone where the service is provided.

Procedures

In the top menu bar, select the target project and region.

Click the Service ID of target endpoint service.

Select the Service Resource tab, then click Edit Auto-assign next to the target service resource.

Check or uncheck the Enable Auto-assign option for the Availability Zones as needed. Click Confirm to complete the actions.

Modify endpoint connection bandwidth

tip

The default network rate for an endpoint connection is 10 Gbps. If this is insufficient, you can adjust it by the relevant steps.

Please note that the actual rate is also limited by the bandwidth of the endpoint service's resources. If adjusting endpoint connection rate limiting still does not improve the network rate, for on-demand adjustments, see Endpoint service bandwidth.

Setting the adjusted rate limit lower than actual business requirements may impact normal service operation. Please proceed with caution.

Use the service provider's account to log in to the Endpoint Service console.

In the top menu bar, select the target project and region.

Click the Service ID of target endpoint service.

Select the Endpoint connection tab, then click Modify Bandwidth on the right of the target connection.

Adjust the rate limit as needed within the range of 100 to 20,000 Mbps.

Click Modify to complete the action.